- PROJECT:
- Design and Fabricate Light Weight Estate Entrance Gates.
- LOCATION:
- 303 Halsey Neck Lane, Southhampton
This is an aluminum gate and fence. The gate is made from 1 1/4" vertical square pickets welded to the horizontal 3"x3"x1/8" channel with radius top. The end posts where the hinge mounts is 3"x3"x1/4" tube and the center posts are 1/8 " thick. There are two gates, one at the main entrance and one at the service entrance.
The main entrance has two radius fences
off either side. These are also made from 1 1/4" square pickets with
2"x1/4" flat aluminum as horizontals front and back riveted
to each picket with the top horizontals on a compound radius hand bent.
The columns are made of wood and Mark M. Cirillo did the installation
of the gates operation mechanism.
|
|
This is a steel
gate 16 feet wide constructed out of 1/4" steel plate with
the design flame cut into 5 separate panels. 2"x3"
square tube was used to connect the panels and 3" angle
was used across the bottom for stability. The panels are split
3 on one side 2 on the other so that the integrity of the design
would not be lost. The design was taken from a piece of African
artwork the homeowner liked and is also displayed elsewhere
in the house.
|
|
  |
|
Highly detailed balcony gate.
|
